I believe it is best to attach the wii remote to the bottom of the overhead projector. This could also be done on a projector that is not mounted …. it would just be the reverse of what you see. You will need the following materials.
- gray pvc pipe for $4.15 for about 8 feet
- PVC cutting tool for about $20
- Iindustrial velcro from Walmart for about $20.00.
The industrial velcro has sticky backing. Place a 4 inch strip perpendicular to the screen and let it dry for 24 hours. Then cut the complementary piece of industrial velcro but don’t take off the sticky backing. It needs to be just larger than the wii remote that will slide in it. This will be about 6 3/8 inches depending if you have the cover on the remote. Attach this to the velcro that is stuck to the bottom of the projector. Finally, adjust the wii remote until you get the right angle. Once you find the right angle, cut a piece of gray pvc plastic pipe to place between the wii remote and the projector. See pictures below.
Entries (RSS)